DIY
I want to recreate this shelve design. I would start by securing the horizontal and vertical base plate to the studs in the wall. But how would I secure the angled piece of supporting plywood? If I secure it to the vertical baseplate, then i limit my access to drilling into the studs. I could maybe brad nail or screw into the base plate at an angle,...
The problem i have is that the dryer function on my machine takes forever to actually dry stuff. With a max load of towels this can take 4+ hours. I know in retrospect that these machines can be problematic in that they don't efficiently get rid of all lint, and that some will build up in the system. I've had service done on it before when i still had...
I ripped out the contractor built-in- place kitchen cabinets in my 1970’s home and hung my new uppers. While the cabinets are level, the soffit above is dramatically not - there’s a 1” rise over 51”. Soffit is covering mechanicals, water lines, etc. for upstairs. Any suggestions how to fill this gap? submitted by /u/Fantastic_Idea7847 [link]...
I found this chair in the trash last week. Looks like and old painter chair or something. Removed the rust, polished and gave it some fresh paint 🎨 submitted by /u/Tough-Education-5390 [link] [comments]
submitted by /u/dirtyr3d [link] [comments]
submitted by /u/Juliares5643 [link] [comments]
خوراک خبری خود را بسازید
آیا آماده هستید تا آن را اجرا کنید؟
بدون نیاز به کارت اعتباری، یک دوره آزمایشی 14 روزه را شروع کنید.